|
3828 viewsTo the left of the sensor hole you can see the new cooler bypass valve - note teeth on ring of input drum lined up with hole for input speed sensor
(4 votes)
|
|
5333 viewsInput drum installed (4 votes)
|
|
3772 viewsInstalling tested input drum into case (4 votes)
|
|
3824 viewsTest fitting input drum on pump assembly (4 votes)
|
|
3746 viewsAppling air pressure to feed holes, to test for proper apply and release of each clutch pack (4 votes)
|
|
3797 viewsSealing rings installed and lubed, pump assembly complete (4 votes)
|
|
3942 viewsAttaching stator support to pump cover and tightening to proper torque (4 votes)
|
|
4037 viewsSome of the durability shift kit documentation (4 votes)
|
|
3799 viewsPump cover cleaned, new front oil seal installed (4 votes)
|
|
3816 viewsNew bushing installed, pinning the bushing so it cannot move or turn in the pump cover (4 votes)
|
|
3780 viewsPump cover with new busing pinned in place (4 votes)
|
|
3796 viewsOld worn out babbit bushing removed (bottom), new sonnax sure-seal bushing (top) ready to install (4 votes)
|
|
320 files on 27 page(s) |
|
|
|
|
|
13 | |
|
|
|
|